DIY Steampunk Monocle Bowler

A fun DIY for Halloween! Great for a steampunk Sherlock Holmes or Watson! This DIY is relatively simple though it can be expensive (if you can't find a bowler for cheap). Here's what you'll need:

Bowler hat (preferably thrifted); Thick Chain (I used 4 inches); Safety Pin; Needle & Thread; Ribbon (mine was ribbon made to look like measuring tape); Small leather pouch; Magnifying glass; Game Spinner; Clock Gear; Jumps Rings; Pliers; Scissors, an Awl; Pins; and a medium Bike Gear (from a cassette)

Steps:

1. Measure the amount of ribbon you'll need to fit snugly around the base of your bowler hat. Be sure to leave at least a 1/2 inch on each side to fold over your bike gear. Once you've measured the amount of ribbon you'll need, cut it. Set aside.
2. Pick up your leather pouch, using your scissors (or an exacto knife), cut 2 slits on the back of your pouch (about 1/4 inch from one another in the same direction--either horizontally or vertically), then thread your ribbon through the slits. Next, using your awl, poke a hole in the front of your leather pouch (so that you can affix your chain to the pouch with a jump ring). Using your flat nosed pliers, attach the chain and the magnifying glass with a jump ring. Optional, also add a game spinner and a clock gear  with jump rings for further decoration.
3. Next, thread your ribbon (with the right side facing up) through your bike gear's holes on one side. Pin in place. Hold your bike gear in place (where you want it situated on your bowler hat and then wrap the ribbon around the base of your hat. Thread the end of the ribbon through the bike gear and pin in place. When you are pinning your ribbon, be sure that you are only pinning the ribbon together and not the ribbon to the hat.
4. Next, slide the ribbon off of the base of your bowler hat and sew the ribbon in place. Keep your stitches small and close together. Be sure to tie a sturdy knot and hide that knot on the side of the ribbon that will go against your hat (and therefore not be seen). Cut off any excess ribbon in the back. Repeat for the other side.
5. Slide your ribbon down onto your bowler hat in place around the base. Place the magnifying glass inside the leather pouch and see how far the chain dangles off of the hat's brim. If desired, using your safety pin, pin the chain to the opposite side of your bowler hat's brim until you want to use the "monocle"/magnifying glass.
6. Wear proudly! As always, happy crafting!

Thanks Stranger!

Thanks to the stranger (a Dwelling Spaces shopper) who gifted me two wrist watches. You brought a smile to my face and truly touched my heart. I am not able to thank you in person so I hope  this will do. Thank You. Thanks to you, and many others who have found me at shows and dropped off bags of broken watches & wayward bits-n-bobs. I have been shown such kindness & support as an artist and it keeps me going. New from my little Steampunk Workshop:

Monocle-Goggles for the Traveling-Reader among you!

Steampunk Countess's Emerald Monocle-Pin.

To fashion to your evening gown or vest, and the monocle unhooked when needed.

I've been on a bit of a monocle kick lately, more inventions are in the works. Of course that does mean I will have to put down Dead Iron at some point...very difficult to do. I recommend it highly though I am still mid-way through its pages.